Clifford intelliGuard 750, Руководство по установке

Страница: 38 / 49

www.directed.com
38
z PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming sequence
or the new code will not be set.
1. Turn on the ignition.
2. Enter the new PIN code.
3. Press and hold for three seconds.
z LED turns on: New PIN code is learned and programming is
complete.
z LED stays off: New PIN code is not learned and the system reverts to
the old PIN code. Repeat the programming sequence.
Note #6: Accessory Channels
z All accessory channels can be programmed to different types of outputs includ-
ing a pulsed output defeated when ignition is on or the system is armed, a pulsed
output regardless of the ignition/armed state, a timed output, a latched output,
or a latched output that resets with ignition on.
z Accessory channel C can be programmed to auto-activate with the arm
command of the transmitter, the disarm command of the transmitter, or both.
Auto-activate can also be turned off and activate as a normal addition accessory
channel output.
fact II - false alarm control technology
FACT II will bypass an input zone for 60 minutes if the system sees the same zone trig-
gered three times within one hour, the system will bypass that input for 60 minutes. If
that zone does not attempt to trigger the system during the 60 minute bypass period,
the system will begin to monitor the zone again at the end of the hour. If it does
attempt to trigger while bypassed the 60 minute time period starts over. FACT II will
also bypass warn away triggers for the 60 minute duration.
FACT II requires that you change the way you test the system once you have it installed.
Resetting FACT II requires the 60 minute time period expiring without attempted triggers
or the ignition to be turned on and off. This allows the system to be repeatedly triggered,
disarmed and rearmed, and still allow FACT II to bypass a faulty zone.
N NO OTTEE:: Remember to reset with the ignition when testing sensors.