CLICK!
Take new reel and press down to close it.
Snap reel fully into the mounting plate.
Turn until the two arrows on the back of the reel
align.
Cycle system to test for smooth function:
Push to engage.
Twist to tighten.
Pull to release.
4–7mm
Up to 15cm
Note: Knot and tail should
not be visible when the lace is seated properly.
Feed right lace through through right lace port.
a)
Attach lace to reel:
Determine lace length needed. Leave a maximum of 15cm of
lace capacity per lace port.
b)
Tie off with a single overhand knot.
Cut tail to 4–7mm past knot.
c)
Pull knot into port. Repeat for
opposite side of reel.
d)
Note: If system feels
rough, remove reel
(see steps 1-2) and
check that knot and
tail are seated
properly (see step 7).
5
6
7
8
9
CLICK!
