Clevo W251BLQ, Руководство по обслуживанию

Страница: 36 / 89

Disassembly
2 - 12 Removing the Keyboard
2.Disassembly
Removing the Keyboard
Figure 8
Keyboard Removal
a. Remove screws from the
bottom of the computer.
Press at points
to un-
snap the LED cover
module.
b. Remove the LED cover
module and screws
from the keyboard.
c. Carefully lift the key-
board up and disconnect
the keyboard ribbon ca-
ble from the locking col-
lar socket.
d. Remove the keyboard.
5
1. Turn off the computer, and remove the battery ( page 2 - 5 ).
2. Remove screws
-
from the bottom of the computer. Press at points to unsnap the LED cover module
(you may need to use the Eject Pin Tool to do this ( Figure 8a ).
3. Remove the LED cover module and screws - from the keyboard ( Figure 8b ).
4. Carefully lift the keyboard up, being careful not to bend the keyboard ribbon cable . Disconnect the keyboard
ribbon cable from the locking collar socket ( Figure 8c )
5. Carefully lift up the keyboard ( Figure 8d ) off the computer.
1 4 5
6
6
7 11
12
12 13
14

Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
four keyboard tabs at the
bottom ( Figure 8c ) at the
bottom of the keyboard
with the slots in the case.
a.
Keyboard Tabs
1
3 2
4
7
5
c.
b. d.
8
9
14
10 11
12
6
5
13

6. LED Cover Module
14. Keyboard
• 9 Screws