Clevo N650DU Series, Руководство по обслуживанию

Страница: 39 / 106

Disassembly
Removing and Installing a Processor 2 - 15
2.Disassembly
Processor Installation Procedure
1. Insert the CPU ( Figure 11a ), pay careful attention to the pin alignment, it will fit only one way (DO NOT
FORCE IT!) ( Figure 11a ).
2. Move the bracket and latch fully in the direction indicated to lock the CPU.
3. Apply the thermal grease to the top of the CPU as shown ( Figure 11b ).
4. Remove the sticker ( Figure 11c ) from the heat sink unit (if it is a new unit).
5. Insert the heat sink unit as indicated in Figure 11c .
6. Tighten the CPU heat sink screws in the order - (the order as indicated on the label and Figure 11d ).
7. Replace the component bay cover and tighten the screws.
A
B C
D
E
F
1 4
b.
B
a.
F
Note :
Tighten the screws in the order as indi-
cated on the label.
A
c.
E
d.
F
2
1
4
3
C
D
Figure 11
Processor
Installation
a. Insert the CPU.
b. Move the latch and
bracket fully in the direc-
tion indicated to lock the
CPU. Apply thermal
grease.
c. Remove the sticker from
the heat sink unit and in-
sert the heat sink.
d. Tighten the screws.

A. CPU
F. Heat Sink
• 4 Screws