Clever airpro, Руководство пользователя, Страница: 6 / 12

6
USING THE HIGH PRESSURE PUMP
Deflating the iSUP
1. Remove any mounted accessories from the iSUP
e.g. stabilising fins.
2. Locate the high pressure inflation valve to the
rear of the iSUP. Remove the cap by twisting
90° anti-clockwise.
3. Firmly press the small pressure release valve
down and twist 90° to open the valve.
Note: the iSUP is under high pressure the air will
release quickly and with force.
4. Begin rolling the iSUP from the front to push the
remaining air out through the open valve.
5. Once empty turn the pressure release valve 90°
to close for next use.
6. Replace the valve cap and turn 90° clockwise
to lock.
INFLATING YOUR
CLEVER
AIRPRO
®
iSUP
2
4 5
3
6
1
Inflating the Clever Airpro
®
iSUP
Maximum operating pressure: 15psi (1.03 bar) must not be exceeded.
• Avoid excessive inflation of the air chamber to prevent danger of the material stretching or the seams bursting.
• Please use the high pressure pump provided with this purchase.
• The hose has an adapter specifically for use with high pressure valves.
• Do not use a compressor or a compressed air bottle to inflate, as this can cause damage to the iSUP and will void any warranty.
• The material may stretch a little following initial inflation and will never return to its original size.
• If you leave the board exposed in the hot sun, check the pressure and deflate slightly if required.
• Pump up the air chamber so that it feels solid to the touch and no wrinkles can be seen in the material. N.B. When fully inflated
small dimples can be seen on the boards top and bottom surfaces.
• Ensure the iSUP is inflated to its recommended pressure before use.
Note : Lay out the iSUP (A) on a flat even surface, making sure it is clear of any sharp objects with the EVA Deck (V) facing
upwards and follow the directions below to inflate:
1. Firmly attach the Pressure Gauge (J) into the High Pressure Pump (H) turning clockwise to lock in place.
Next attach the end of the pump hose (I) into the pressure gauge (J) turning clockwise to lock in place.
2. Locate the high pressure inflation valve (VII) to the rear of the iSUP and remove the cap by twisting 90° anti-clockwise.
3. Twist and push the end of the pump hose (I) into the high pressure valve on the iSUP (A).
4. Inflate the iSUP (A) using the high pressure pump (H) until fully inflated to the recommended pressure.
5. Once fully inflated remove the pump hose from the high pressure valve by turning 90° anti-clockwise.
You may hear a small rush of air for a second as the hose is removed.
6. Replace the valve cap (VII) to ensure the iSUP is air tight.