Clever Acoustics ZM 102, Руководство пользователя

Страница: 6 / 12

www.cleveracoustics.co.uk ZM 102 Audio Mixer User Manual
6
Operating instructions
9. Power Indicator LED
The Power LED will illuminate to indicate the zone mixer is powered on. If the power LED is
not illuminated, check first the position of the on/off switch and then check the mains supply
(including fuse).
10. Chime Output Select
The chime function may be routed to output zone 1, output zone 2 or both. Use the slide switch
to select as required.
11. Signal Indicator LED
Each of the input channels features an LED to give a visual indication if an input signal present
on the relevant channel.
12. Output Zone Routing Selection
The output of each individual input channel may routed to output zone 1, output zone 2 or both.
Use the slide switch to select as required.
13. Priority Selection
The user may select from either MIC/LINE2, MIC/LINE3 or MIC/LINE4 to be highest priority. Using a
small screwdriver, carefully remove the small protection cover to the right of MIC/LINE2 in order to
reveal the three way dipswitch. To switch priority ON for a given channel, move the dipswitch to the
ON position. Note: Only one channel should be selected at any one time.
14. Master Zone 2 LF/HF Controls
During initial setup the high frequency and low frequency tone adjustments should be set to the zero
point (3 O'clock position). Turn the level control anti clockwise to reduce the high/low frequency tones,
or turn clockwise to adjust the increase the high/low frequency tones. Adjustments should be made
gradually to avoid any sudden changes to the audio output.
15. Power Switch
On/Off control for the zone amplifier.
16. AC Mains Power Input
240V~50Hz AC mains voltage input. This product falls under CLASS 1 and must have a protective
earth connection at all times.
17. DC Power Input
For connection to battery backup power sources, or for operation from leisure type batteries. The ZM
102 mixer may be used from 24V DC power sources. Care should be taken to ensure an inline fuse is
fitted to the +ve supply and the power is connected with observing the polarity.
18. Balance Main Outputs
Balanced, +4dBu mono outputs for each of the two output zones. Each zone output features
a male XLR connector.