User Manual – ZPLUG
UM_ZPLUG_20090903_001_04_00.doc
CLEODE Page 11 sur 14
III I
NSTALLATION AND
W
ORKING
III.1 I
NSTALLATION
The user has to plug the ZPLUG on a socket in the wall and plug the appliance on it.
At plugging, the ZPLUG sends beacon request on the network. If a ZigBee coordinator or
router is able to associate the ZPLUG the ZPLUG enters in the network.
III.2 W
ORKING
III.2.1 O
N
/O
FF SWITCHING
The first time the ZPLUG is plugged in the socket, the switch is ON.
In each switching, the ZPLUG keeps the value of the attribute ON / OFF in memory not
volatile. Consequently, if a power cut or a disconnection of the ZPLUG arrives, this one will
find the state of switching in the restart.
This switching can take place of two different ways:
By pressing on the present button in facade,
By sending a command on ZPLUG by the connection ZigBee.
When the output of the ZPLUG is fed, the LED of the ZPLUG is lit in red otherwise it is put
out.
III.2.2 R
ESET
ZPLUG
To make a reset of the network parameters of Zplug, you have to press on the button during at
least 5s.
III.2.3 S
CAN OF THE NETWORK
If your Zplug does not find a network available ZigBee it will make automatically a new scan
at the end of 15 minutes. This time will increase twofold every time the ZPLUG makes a scan
without finding of available network.
If you wish to boost a scan of the network manually you have to press during 3 seconds on the
button of the ZPlug, this will have the effect of making the LED of the ZPLUG flash. If your
ZPlug is already associated, presses it during 3 seconds on the button will have no effect