User Manual: ZCARE : Warning Wristband
CLEODE
page
14
of
22
To swing a Zcare in Standby mode proceed as follow:
Figure 6 : Swinging Procedure in Standard mode
1)
The Zcare has to be first in Standard mode: if necessary perform the previous procedures to arrives at this
state
2)
Approach the magnet on the
LED NWK side then click on call button:
3)
The ZCare switches on LED NWK in fixe Orange during 2 seconds to inform its new state (Standby mode) :
III.5
Procedure to switch in config mode
Config mode allows to configure the functions of the wristband (Cf. Chapter Software Interface V).
To switch in configuration mode, proceed as below (we consider here that the wristband is already associated to
the ZigBee® network) :
Figure 7 : Procedure to switch in config mode
1)
The Zcare must be initially in Standby mode : if necessary perform the previous procedures to reach this
state
2)
Approach the magnet to the LED NWK side:
3)
The ZCare flashes 2 times Red to signal its search phase to the ZigBee® network:
4)
After pairing the Zcare signals its reintegration in the ZigBee® network by lighting the LED NWK in solid
red during 2 seconds :
5)
The ZCare switch in configuration mode, it is reachable by the devices of the integrated network
(POLL_RATE one (1) second)
