Clemco Spin - XL, Руководство пользователя, Страница: 8 / 15

Page 8 of 15
5.2 Maintenance cycles
Maintenance
cycles for
steel shot
(working
hours) Risk of wear!
Demolition of equipment.
max. 8h Nozzles and blast head. Check and replace if necessary sealing of
nozzles and blast head.
max. 16h Plastic sealing. Check and replace if necessary.
Carbide insert head. Check and replace if necessary.
Shaft and felt seal. Check and replace if necessary.
Shaft seal position: open side to back!
max. 30h Ball bearings. Check and replace if necessary.
max. 50h Moisture separator. Clean only with soap and warm water.
Air and blast hoses. Gaskets of couplings for wear. Blast hose
by hand for soft spots.
Blast pot. Pop up valve for wear by hand.
max. 300h Air motor. Maintenance by Clemco or service man of
producer.
5.3 After other periods of time
Article replace (even without wear) after maximal
Blast hoses 6 years
Remote control hoses 6 years
Air hoses – external air supply 6 years
O-rings 5 years
Pop up valve (blast pot) 5 years
Gaskets 5 years
6 Troubleshooting
Problem Probable cause Remedy
Blast head
does not turn or
too slowly 1. Volume or pressure of air at motor is
too less.
Increase volume/ pressure of air for air
motor.
2 Leakage/ bend in supply hose of air
motor.
Replace or place straight.
3. Width/ length of supply hose unsuitable. Width of hose 6mm: max. 10m
Width of hose 9mm: max. 20m
4. Entered dust interlocks axle. Felt seal/ shaft seal/ ball bearing wear 
replace
Irregular blast
result. 1. Pulsing blast media. Reduce metering.
2. Moist blast media. Replace blast media with dry one.
Vibrations. 1. One nozzle blocked. Eliminate blockage.
2. Different sizes of nozzles. Use equal nozzles (length and diameter).
3. Fixture wheels loose. Tighten screws.
7 Admitted modifications for users
Only with the improvement of the producer! Otherwise the installation will loose guarantee and CE-
certification