Clemco CDF-12, Руководство пользователя

Страница: 9 / 16

CDF MODULAR DUST COLLECTOR Page 8
© 2017 CLEMCO INDUSTRIES CORP.

www.clemcoindustries.com

Manual No. 23478 Rev D
2.9.4 Make sure tubing is connected between the
snubber fittings and differential-pressure indication-panel
as shown in Figure 5.
Figure 5
2.10 Install Filter Cartridges, Refer to Figure 6
NOTICE
Use extreme care when handling the cartridges.
Minor dents could cause the cartridge to leak.
2.10.1
Slide two cartridges (gasket end first) over the
support guide.
2.10.2 Place the cover plate (make sure the rim gasket
is in place and the cartridge gasket is toward the inside)
over the support rod.
2.10.3 Place the rubber-backed washer (rubber facing
the cover plate) over the support rod.
2.10.4 Tighten the tensioning knob securely.
2.11
Dust Containers, Refer to Figure 7
2.11.1 Place a dust drum under each hopper and
securely attach a lid to the drums. NOTE: Place the
drums on a pallet if their removal will be with a forklift.
Figure 6
Filter Cartridge
Cartridge Gasket
Cover Plate
Face-gasket must be toward the cartridge
Cover-Plate Face Gasket
Cover Plate
Rubber-Backed Washer
Tensioning Knob
Install both cartridges, gasket end first
Washer and tensioning Knob
Support Guide
Cover-Plate Rim Gasket
Cartridge Gasket
Dirty side of collector
(dust hopper)
Snubber Fitting
1/4

Tubing
In-Line Filter
High-Pressure Line
Low-Pressure
Line
Differential-Pressure Gauge
Manifold-Pressure Gauge
To Pulse Manifold