BEACON LED BLAST LIGHT
Page 2
© 2017 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 27765 Rev. B
Figure 1
2.0 SET-UP
2.1
Assemble Mount to Light Assembly
Refer to Figure 2
2.1.1
Slide the light mount into the slot on the light
assembly; the mount is tapered and inserts in only one
direction into the slot. Secure with the socket head screw
provided.
2.1.2
Use the cap screw provided to attach the
mounting bracket to the light mount. Secure with the lock
nut provided.
Figure
2
2.2
Assemble Light to Blast Hose
Refer to Figure 3
2.2.1
Use cable ties provided or user-supplied worm
clamps or tape to attach the light to the blast hose,
nozzle holder or nozzle, as shown in Figure 3. When
attaching the light to a slick surface, such as a nozzle or
nozzle holder, use adhesive-backed gasket to prevent
the light from slipping. To apply, cut two lengths of
gasket long enough to wrap around the holder; remove
the backing and apply the gasket around the holder,
spaced so one length of gasket is under each end of the
mounting bracket, as shown. Shorter couplings may
require the gasket strips be placed closer together.
Figure 3
2.2.2
Wrap the cable ties around each end of the
mounting bracket, as shown in Figure 3, and loosely but
secure enough to barely hold the light in position.
2.2.3
Make sure the light is aligned with the nozzle;
the pivot adjustment will be done later. If the light is
attached to the hose, and it is too far from the nozzle,
bends in the hose will direct the light beam away from
the blast stream.
Mounting Bracket
Cap Screw
Lock Nut
Socket Head Screw
Light Mount
Mount Slot
* Used only with 120-volt lights
** Used only with 12-volt lights
Blast Light Assembly
**12-volt DC Supply Cable
10-ft., 50 ft., or 100 ft.
*120-volt AC Supply Cable
10-ft., 50-ft., or 100-ft.
*AC Junction Box
*4-foot Power Cord
w/120-folt AC U-ground Plug
Cable Ties (2)
5/16" x 1" Adhesive-Backed Gasket
2 feet supplied, refer to Paragraph 2.2.1.
**Clamps, (+) positive and negative (-)
Wrap cable ties
around bracket.
Cinch the ties to secure.
Mounting Bracket
Wrap adhesive-backed
gaskets around nozzle
or nozzle holder.
