STARTING AND USE INSTRUCTIONS
I115SS
Rev. 001
07/10/14
37/49
4.7.9 WASHING BRUSHES AND BLADES REPLACEMENT
Please follow the instructions below:
Remove the ignition key from the dashboard in order to avoid the accidental start of the machine
after having translated the brushes plate outside.
Remove the split pin that hold the bumper wheel support pin (see detail 1 in picture nr. 4.20);
Remove the right brush turning it until you can see the pin, pull the pin and remove the brush (see
detail 2 in picture 4.20);
Set the new brush up: place it under the exagonal support and press it up (see detail 3 in picture nr.
4.20);
Start now the machine, place the brushes plate in its original position and switch the machine off;
Follow the same instructions for the left and central washing brush;
After having replaced the brushes, the operator has to set the cases and the split pin up again;
Blade replacement: the operator has to unscrew the screws on the case and replace the blade.
Before starting the machine again, please make sure that all the protection cases are well
set up.
FIGURA N° 4.20
2
3
1