FUNCTIONING
GIAMPY
Rev. 00
15/02/2012
Pag. 33/43
BRUSHES BELT REGULATION AND REPLACEMENT
Take the ignition key away from the dashboard in order to avoid a casual starting of the
machine;
Uscrew the four screws and remove the plastic case (detail 1 in picture 4.20);
Tighten the nut of the belt (detail 2 in picture 4.20) fixed on the eye in order to increase the
spring strength which regulates the belt (see detail 3 in picture 4.20);
Unloose the nut mentioned above in order to remove and replace the brushes belt;
Tighten the nut so that the brushes belt has the same strenght as before;
Set the brushes case up again by means of the four screws.
4.7.9 SQUEEGEE BLADES REPLACEMENT
The squeegee blades (picture 4.21) have to be replaced as the touching edge is worn; actually the perfection
Of the edge is essential for a perfect drying.
To replace the blades do as it follows:
Take off the squeegee and put it on a bench.
Take away the inside and outside bolts (detail 1 picture 4.21), the steel strips (detail 2 picture) and
remove worn blades (detail 3 picture).
Insert the new ones and the strips fitting the bolts, then the squeegee.
PICTURE N° 4.21
2
3
1
1 2 3
PICTURES N° 4.20
