Cleco MA3S358M, Инструкция по эксплуатации

Страница: 21 / 36

Page 21
PL70-1046EN
07/08/2013
Cleco
®
Repair Instructions
9.4 Geared models: assembly (continued)
Place the gear and pinion, with bearing, into the bearing housing (MA3G20) making sure the •
bearing bottoms out in the housing.
Assemble the bearing housing (MA3G39) to the bearing housing (MA3G20) and secure using
•
washers and screws. Tighten the screws to 21 ft. lbs. (28.5 Nm) torque.
Slide the gear and shaft into the gear housing and tap in until it bottoms out.
•
Place the bearing housing gasket (MA3G25) over the bearing housing and assemble the bearing •
housing to the gear housing. Secure using washers and screws. Tighten the screws to 21 ft. lbs.
(28.5 Nm) torque.
Place the motor case gasket (MA319) over the motor case and assemble the motor case to the
•
gear housing assembly, breather hole up. Secure using washers and screws. Assembly two (2)
screws (75P56) to the left of the breather hole and three (3) screws (75P5) to the right of the
breather hole. Tighten the screws to 21 ft. lbs. (28.5 Nm) torque.
Make sure the pipe plugs and pet cock are securely installed in the motor case and gear housing.
•
Fill the motor case with 3/4 pint of oil and the gear housing with 1-1/2 pints of oil. •
12J36
Bearing
Gear and Shaft
12J7
Bearing
MA3G40R
Wear Ring