Cleco A24T, Руководство по обслуживанию и запасным частям

Страница: 8 / 100

Page 8
PL92-5013EN
10/06/2017
3 Maintenance:
General Notes:
Note: Intervals between inspection depend on a number of operation and use factors, most significant of which
are:
• the operation frequency of the tool
• number of drilling cycles per use
• drilling torque and thrust required
• cycle time in use
• cleanliness of operation - lubricant/chip cleanup
• quality of air supply
The following recommendations are initial guidelines and should be adapted according to the tool utilization.
For additional information or guidance please contact your local Apex Tool Group representative.
Recommended Minimum Service Intervals *
* Recommended Service Interval is based on 3 possible factors - Calendar Time, Run Time or Run Cycles - the
number achieved first should be used to set maintenance schedule
** Alternatively Before or After Each Shift
Calendar
Time
Cycles
Run
Time/hrs
Action
Daily ** NA NA Ensure tool is cleaned - all chips/debris removed
Visually Inspect air supply hose, all pneumatic connections
Inspect airline filter, regulator and lubricator for proper lubrication
Check Air Supply Pressure (90psi dynamic)
Check spindle stop nuts are securely mounted
Check all guards are fitted
Check the tool for excessive vibration/unusual noise
Visual inspect all external components - Especially inder if fitted for wear
Check Tool Function - Emergency Stop/Start/Manual Retract/Automatic Retract
Perform test drill before each shift
3 Months 100,000 500
Check Motor Speed - If Low Clean Inlet Screen and Clean or Change Muffler then
check/replace Motor Blades as necessary
Check for External Air Leaks - Replace O Rings as necessary
Inspect Fluid Inducer End Seal/Tube for wear/leaks - replace if necessary
Apply grease to Gear Head
Check operation of Lubricator
Check thrust overload setting
6 Months 200,000 2,500 Inspect All O Rings/Seals - Replace as necessary
Check spindle for wear on threads
1 Year 300,000 7,500 Replace All Bearings/Inspect Gears - refer to spare parts manualfor guidelines
Check All springs
Product Information