Cleco 35PHH Series, Инструкция по эксплуатации

Страница: 11 / 40

1994b_1_5_en-bedingt.fm, 12.06.2014
P1993BA/EN 2014-06 11
Before initial operation
4
Oils according to DIN 51524 / ISO 3498
4.2 Change air inlet: top / bottom (only on 35PHHA)
When delivered, the air inlet is at the BOTTOM and sealed with a screw plug. To change the air supply from
top to bottom:
 Remove the air strainer from the air inlet at the TOP (do not discard), see 8.2 Pistol grip 35PHHA…,
page 30, Detail
X .
 Remove screw plug from BOTTOM. When doing this, counterhold with wrench (WAF 17).

Seal the air inlet at TOP with screw plug in accordance with specifications.
4.3 Connect the tool
 Connect the tool to the compressed air line.
Maximum screwing-in torque = 40 Nm. Reaction torque at flat end. Counterhold with wrench (WAF 17).
 Activate compressed air: 620 kPa.
Lubricator Compressed air requires a small amount of oil and is orientated to
the air consumption of the tool.
 Calculate the time ( T ) between two drops of oil and make the
following settings at the lubricator:
F = Factor for pulse nutsetter = 2
L = Air consumption of tool at idle m³/min
(see performance data for pulse shut-off nutsetter)
Order
no.
Packaging
unit
Liter
Name ARAL BP elf ESSO INA Mobil Klüber SHELL
933090 2 HL32
Aralub
EE 100
Energol
HL 32
Polyelis 32
Olna 32
Nuto
H 32 Hydraol
32A
D.T.E.Oil Light
Vactra Oil Light
Crukolan 32
Molina 32
Molina 22
CAUTION!
The air hose can come off by itself and whip around uncontrollably.

Shut off the compressed air before making the connection.
Device Explanation
T
60
F L

------------- =