Cleco 20PHH, Инструкция по эксплуатации

Страница: 8 / 38

8 P1992BA/EN 2014-06
1994b_1_5_en-bedingt.fm, 12.06.2014
Before initial operation
4
3.2 Options
4 Before initial operation
4.1 Air supply
 Make sure that the pressure before the pressure regulator is at least 0.5 bar higher than the required
inlet air pressure at the tool.
 Keep the inside of the air hose free of residue; clean it if necessary.
Air quality
In accordance with ISO 8573-1, quality class 2.4.3, compressed air must be dry and clean.
Air preparation units
Our recommendation: air preparation units (filters, regulators, lubricators) should be installed
Protective sleeve
Order No. 937447PT – 20PHH…
Order No. 937442PT – 20PHHA…
Parameter Data
Air hose Inner diameter 3/8" (ø 9.5 mm), maximum length 5 m
Air inlet 1/4" NPT, inner diameter

7.5 mm
Parameter Data
Working pressure range 400 … 700 kPa
Max. dew point + 10° C
Device Explanation
Filter Retention of particles > 15 micrometers.
Removes more than 90% of condensation.
Regulator To attain constant work results, the working pressure must be
kept constant for every individual tool.
Lubricator Compressed air requires a small amount of oil and is orientated to
the air consumption of the tool.
 Calculate the time ( T ) between two drops of oil and make the
following settings at the lubricator:
F = Factor for pulse nutsetter = 2
L = Air consumption of tool at idle m³/min
(see performance data for pulse shut-off nutsetter)
T
60
F L

------------- =