Page 9
Step 3: Clearwater Speaker Installation
F
G
f) Place the tweeter wire in the “groove” with the factory input wire and
hold in place with a small zip tie. Cut off the end of the zip tie.
g) The factory tweeter wire will not be used. Wrap the factory tweeter
wire around itself and hold in place with a small zip tie. (the tweeter
wire will make a rattling sound if it is left loose) Cut off the end of the
zip tie.
Door Speaker:
• Plug the wires coming from the sound module labeled “woofer” into
the rear of the Clearwater door speaker. The red wire connects to the
“red” terminal, the black wire connects to the “black” terminal, the white
wire connects to the “white” terminal, and the green wire connects to the
“green” terminal.
• Make sure that the included gasket is securely attached to the frame.
• The water shield is provided to protect the speaker from the top, not the
bottom.
• When properly installed, the water shield should be located at the top of
the speaker as shown below and the terminals to the left and right (front
and back of the car).
