ClearView IPPTZ-EL2MPIR250L30X-E, Руководство по установке

Страница: 9 / 29

1
1 IR INTELLIGENT SPEED DOME INSTALLATION
1.1 Installation Preparation
Basic Requirement
z All installation and operation here should conform to your local electrical safety codes.
z Before installation, please open the package and check all the components are included.
Please make sure the speed dome installation environment and installation mode can meet
your requirement. If there is special requirement, please contact your local retailer for more
information.
z
We assume no liability or responsibility for all the fires or electrical shock caused by
improper handling or installation.
Check installation space and installation location intension
Please make sure the installation environment has enough space to install the speed dome and
its corresponding bracket.
Please make sure the ceiling, wall and the bracket can support the speed dome and its
corresponding installation component. It shall sustain the 4X weight of the speed dome.
1.2 Initial Setup
The default setup is:
z Address: 1
z Baud rate: 9600
z Parity: None.
1.3 Dial Switch Setup (For Analog Speed Dome Only)
1.3.1 Dial Switch
There are two dial switch buttons on the PCB of one side of the speed dome (There are labels.).
You can use them to set speed dome protocol, baud rate, address and etc. See Figure 1-1 . It is
1 when you set the button as ON.
For the protocol dial switch, you can refer to the following sheet. 1 is the lowest bit and the 8 is
the highest bit.
1 2 3 4 5 6 7 8 ON
NC
120
Ω Parity Baud rate
Connect to the 120
Ω
Please note the IR speed dome can automatically recognize the DH-SD, PELCO-D. PELCO-
P. Usually you do not need to set the protocol.