ClearView HD4112, Руководство пользователя

Страница: 14 / 14

7. System Setting
Press
Setup then Setup System
You can reset the unit to Factory Default or just Hardware Reset by clicking on this
dropdown here. Be sure to always press the Save Settings to the left after selecting your
option. The IP Address of the unit can be adjusted in the 192.168 range. The last 2 sections
are adjustable
here .
You can save the Modulator Config by pressing This Button .
It can be re-loaded by Choosing the File then uploading it into the Modulator.
After all settings have been adjusted always press the-
Store Settings and Reboot System for them to be saved completely.
When using more than one unit in an installation, use the
RACK POSITION feature
To set parameters differently in each modulator in the rack so they do not interfere with
each other. The values can be overridden and saves in the SETUO RF and TS menus if you
have other units in the system with same parameters. Press Rack Position
SAVE SETTINGS
to save rack position. It will take a little time to re-boot and save.
If the buttons turn grey while you are adjusting settings, Log out then back in again
To activate them.
The STATUS but only shows you status of the device and changes cannot be made in this
menu.