HD168Bi Manual Rev 1.0
3.2 Starting
3.2.1 Beginning Setup
DEVICE Programming and Setup
1. Apply power.
2. Connect Audio / Video source
Connecting to the GUI Interface:
1. Connect an Ethernet cable directly to the Ethernet port on the rear panel of the encoder
and then connect the Ethernet cable to an Ethernet switch /router or connect an
Ethernet Cable to your PC.
2. Using a Windows-based PC Select Windows Icon
3. The default IP address is
192.168.1.138
Make sure your PC has the same 3 first section IP
range.
4. Key in the IP address in web browser 1 9 2 . 1 6 8 . 1 . 1 3 8
3.2.2 Step 1: Login and Adjust RF Settings
Login Password:
Default Password: 1 2 3 4
Encoder Programming and Setup via GUI Interface and click on
SETUP
then on
RF Out
:
Set your Country and frequency
here
. Once set press the
Save Settings
button to the left. It
is the same with Output Level, Service Names, LCNs, Service IDs, Network IDs and Network
Names. When setting Service names, lower case letters will be converted to capitals on SAVE
If the name contains less than 15 characters. You need to press
Save Settings
to the left of
each group. After setting all these parameters, you need to press the-
Store Settings and Reboot System
for them to be saved completely.
