8
Revision date: 05.28.10
Twin-Wall Double Swinging Doors
DoubLe TWIN-WALL DooR ASSeMbLY (continued)
With assistance, set the assembled doors in the end
14.
wall door frame and secure hinges to the door jamb
using one Tek screw per hinge at this time
.
Locations of door hinges may vary.
Place one (1) main handle of assembly through hole
10.
in door and twist main handle and front plate into
place as shown in the drawing below.
Mark the plate mounting hole locations on the panel
11.
and drill a 5/16" hole through the panel and door
frame. Support frame with a block of wood if needed.
Slide back mounting plate into position, square it with
12.
the mounting holes and front plate and secure using
two (2) ¼" x 3" bolts and lock nuts. Verify that latch
turns freely. Mount one (1)
door latch guide
(slotted
plate) using the remaining ¼" x 3" bolts. Position so
latch handle is level. See below.
Horizontal
Position
Door Latch
Guide
Latching
Plate
NoTe:
Verify that there is sufficient clearance along
all door edges to allow the doors to swing freely in
the opening.
If end panels are installed, either attach
to the outside of the end panels as shown above or
loosen the panels, secure the hinges directly to the
door jamb, and reinstall panel fasteners.
Test the door operation, adjust hinges as needed,
15.
and install the remaining Tek screws.
Attach the 6" chain bolt to the inside, upper corner of
16.
the door without the handle
(see X in drawing below).
Mount the latching plate to the outside of the same
door (see drawing in step 12).
The screws supplied
with the latch are not used for metal jambs
.
After assembling the doors, evenly space the three
13.
(3) hinges along the door frame of each door and
attach the hinges to each assembled door using Tek
screws.
Inside
View
outside
View
Door
without
handle.
X
