4
Revision date: 05.28.10
Important Information
PARTS IDeNTIFICATIoN
The following graphics and photos will help identify the
different hardware for each door kit. (Some parts are not
shown.)
Corrugated Polycarbonate Double Door Kit
(R035b00011b)
FA4482B
Tek screws
102921B
Neo-bonded washers
108553
Wafer head screw
Twin-Wall Polycarbonate Double Door Kit
(R035b00011A)
102921B & FA4484B
Tek Screws and neo-
bonded washers
104213
Aluminum
U-Channel Profile
108553
Wafer head screw
ASSeMbLY PRoCeDuRe
Following the instructions as presented will help ensure
the proper installation of the end frame and doors. The
steps outlining the assembly process are as follows:
Verify that all parts are included in the shipment.
1.
Notify Customer Service for questions or concerns.
Read these instructions and all additional
2.
documentation included with the shipment
before
you begin.
Gather the tools, bracing, ladders (and lifts), and
3.
assistants needed to install the doors and door
frame.
Read the care and maintenance information at the
4.
end of these instructions.
Complete and return all warranty information as
5.
instructed (if included).
uNPACK AND IDeNTIFY PARTS
The following steps will ensure that you have all the
necessary parts
before
you begin.
Unpack the contents of the shipment and place
1.
where you can easily inventory the parts. Refer to the
Bill of Materials/Spec Sheets.
Verify that all parts listed on the Bill of Materials/Spec
2.
Sheets are present. If anything is missing or you
have questions, consult the parts guide and all
diagrams for clarification, or contact customer
service.
NoTe:
At this time, you do not need to open the
plastic bags containing smaller parts such as
fasteners and clamps (if equipped).
QuICK START DIAGRAMS
For a quick overview of the end wall, doors, and
components, consult the diagrams located at the back of
these instructions.
104548
End Cap
104548
End Cap
