CLEARSPAN
™
GARAGES & STORAGE SHEDS
9
Revision date: 06.11.08
FRAME ASSEMBLY (CONTINUED)
10. Continue adding rafters and purlins until the frame is
assembled.
NOTE:
Remember to slide a band clamp onto each
bottom purlin between the second and third rafters at
the remaining end of the shelter.
11. Finish each purlin with one 73.5” pipe and use the final
end rafter to complete the assembly.
MOUNTING BOARD INSTALLATION
The mounting board is supplied by the customer. For this
example, it is attached
above the bottom purlin
along both
sides of the frame
on the inside of the frame.
Consult the
diagrams in the Quick Start section to view the mounting
board installed below the lower purlin.
ATTENTION:
Use the pivot wheel assembly to measure
the required height of the mounting board.
Building frame
must rest on all rafter legs when the wheel assemblies are
in the retracted position.
Gather the parts: (All mounting boards and fasteners are
supplied by customer.)
• 2" x 6" (or larger) boards at required length
• Fasteners to secure mounting boards to frame
• 1/4" x 4" carriage bolts and 1/4" nuts
NOTE:
The following procedure describes one way to
install the required mounting boards. The size and type of
the boards chosen may require the use of alternative steps.
When properly installed, mounting boards run the length of
the shelter on the inside of the frame.
1. Measure the board height needed using the wheel
assembly in the retracted position and mark the
locations on the rafter legs.
NOTE:
Building frame must rest on all rafter legs when
the wheel assemblies are in the retracted position.
2. On the inside of the frame, attach the first board to the
end rafter
using two (2) carriage bolts and hex nuts.
NOTE:
DO NOT allow the mounting boards to extend
beyond the end rafter. Boards must be flush with end
rafter.
View shows the frame from the outside.
Band Clamp
Mounting
Board
Carriage
Bolts
U-Bolts
Mark
here
The diagram below shows the mounting board installed
above the lower purlin. Consult the diagrams in the Quick
Start Guide to view the mounting board installed below the
lower purlin.
Either application is acceptable.
Consider the
building use when attaching the mounting boards.
NOTE:
To prevent cover damage, DO NOT allow the
purlin to extend beyond the end rafter.
12. Return to each clamp and install a Tek screw through
the clamp and into the purlin pipe as shown.
13. Secure each clamp to the rafter using a Tek screw.
End Rafter
Tek
Screw
Tek
Screw
Interior
Rafter
Purlin
Purlin
14. Continue with the installation of the mounting board.
