15
CLEARSPAN
™
ECONOMY MOO-TEL
™
Revision date: 01.26.18
INSTALL THE ROLL-UP SIDE CONDUIT
Gather the parts:
• Pipe 1.315'' x 75'' swaged (#131S075)
• Pipe 1.315'' x 73.5'' plain (#131P0735)
• Tek screws
The roll-up side conduit assembly is attached to the bottom
of the roll-up side cover material. This assembly runs the
length of the frame and serves as the center pipe that the
roll-up cover wraps around when it is opened to ventilate
the shelter.
This conduit is identical to the purlins that were
assembled and attached to the frame.
Complete these steps to assemble the roll-up side conduit.
1. Locate all sections of pipe needed to assemble the
cover conduit.
2. Insert the swaged end of each pipe into the plain end of
another pipe until the conduit is assembled.
3. Secure each pipe joint with a Tek screw.
INSTALL THE ROLL-UP SIDE ASSEMBLIES
The instructions below describe how to install a single
roll-up sidewall assembly for one side of the frame. The
procedure is repeated for the remaining side.
The procedures to install the roll-up side include the
following:
1. Assemble the roll-up side conduit.
2. Attach the roll-up conduit to the bottom of the main
cover.
3. Assemble the Twist-of-the-Wrist assembly and attach it
to the frame and the roll-up side.
4. Install the Anti-Billow Rope system.
5. Test the operation of the roll-up side.
4. Place the assembled conduit at the base of the side
where the end of the main cover is located.
NOTE:
Duct tape Tek screws to prevent damage to
main cover.
5. Continue with the procedure that follows to attach the
conduit to the main cover.
ATTACH CONDUIT TO MAIN COVER ROLL-UP SIDE
Gather the parts:
• Assembled conduits
• Fabric clips #CC6212 (Divide quantity in half.)
• Tek screws
To this point, the main cover should be secured to the
frame and the excess cover along both sides should be
hanging down along the side of the frame.
1. Unfold the remaining portion of the main cover (if
needed) and evenly stretch it out on the ground along
the frame.
2. Working from
the inside the frame
, roll the assembled
cover conduit onto the edge of the main cover.
3. Verify that the cover and conduit are evenly positioned
and tuck the cover edge under the conduit and roll the
conduit to wrap the cover around it one to two turns.
4. Using one-half of the fabric clips (CC6212) and Tek
screws, secure the cover film to the cover conduit.
Evenly space the clips along the conduit for best
results. See insert above.
5. Continue to roll the conduit until the excess cover
material is wound around the conduit and the conduit is
positioned on the ground at the base of the assembled
frame.
6. With the excess cover material rolled onto the conduit
assembly, continue with the
Twist-of-the-Wrist
Assembly
procedure.
Shelter shown above may be a different model.
Drawing used for illustration only.
Inside View
Clip
