ClearSpan CL108544, Руководство пользователя

Страница: 16 / 19

CLEARSPAN
™
FABRIC STRUCTURES
16
Revision date: 09.08.09
INSTALL THE PVC CONDUIT FOR MAIN COVER ENDS
For some covers, the PVC conduit is inserted into a pocket at each end of the
main cover. Strapping is then threaded around the conduit and the end rafters.
This strapping is evenly tightened to stretch the main cover end-to-end.
Required parts and tools:
LJ2842 (3/4" PVC conduit) and 103620E (1" strap) •
Duct tape, Tek screws, and driver for Tek screws •
Tool to cut strap, a lift or ladders to reach top of frame, and assistants to •
install and tighten strap
Photo shows the stretch pocket
and the conduit and strapping as
installed for a similar main cover.
View shows the cover as seen
when standing inside the frame
looking up at the end rafter.
Main
Cover
Strap
PVC Conduit
End Rafter
Notched Stretch
Hem Pocket
PVC conduits installed near the ends of the main cover provide an additional
tie-down position. Complete these steps to install the conduit and strapping for
the stretch pockets of the main cover.
Take the first section of PVC conduit and feed it into the stretch pocket from 1.
the bottom at one end of the cover.
Insert the plain end of the conduit into
the pocket so the next section can be joined to the first.
Photo shows a similar cover and
the location of the stretch pocket.
Cover is shown with the underside
facing up, which is the side visible
from inside the frame when the
cover is installed.
For some covers, the notched
portion of the stretched pocket
is removed in the field by the
customer.
Photo shows the notched
stretch pocket and the
installed PVC conduit at the
end of a similar main cover.
NOTE: Some covers may
not ship with the pocket
material removed for the
installation of the straps. If
slots need to be created,
cut only the cover pocket;
do not cut the main cover.
Space slots approximately
24" apart (on-center) if
these need created.
Notched Stretch Hem
Pocket
PVC Conduit
Notched Stretch
Hem Pocket
End of main cover
where bonnet strap
is located.
Sample Main
Cover to show
pocket location.
Once the bell end reaches the pocket, take another section of PVC conduit, 2.
insert the plain end into the bell end of the previous section and secure the
joint using a Tek screw or customer-supplied PVC glue.
NOTE: Wrap the Tek screw
and joint using duct tape.