CLEARSPAN
™
HIGH TUNNELS
18
Revision date: 05.08.12
TWIST-OF-THE-WRIST ASSEMBLY (CONTINUED)
Slide the Twist-of-the-Wrist assembly onto the
12.
aluminum channel from the ground end. (This is the
free end of the channel.)
Finish rolling the cover conduit until it reaches the
13.
Twist-of-the-Wrist assembly.
Attach the rolled conduit to the square shaft of the
14.
assembly by inserting a 5/16" machine bolt through the
hole in the conduit and tubing adapter. Tighten the nut.
NOTE:
It may be necessary to trim the conduit and
cover to the proper length so that it aligns with the
gearbox. Adapt these instructions to your application.
Attach the crank handle to the Twist-of-the-Wrist
15.
assembly. (Cover is not shown in the above diagram.)
Test the operation of the Twist-of-the-Wrist assembly.
16.
NOTE:
If the cover rolls in the desired direction, but
you want to turn the crank in the opposite direction for
the same result, unbolt, reposition the gearbox, and
remount it on the same side of the mounting bracket.
Space below is reserved for customer notes.
Roll-Up Cover
Conduit
(Cover is not
shown.)
