CLEARSPAN
™
GREENHOUSES
18
Revision date: 07.22.11
INSTALL THE END WALL FRAME (continued)
Locate the 100356 lower roller assembly and remove
34.
the roller, bushings, screws, bolt and nuts.
Looking at the rough door opening of the assembled
35.
end wall, secure the angle bracket in the lower-left
corner of the opening as shown below.
NOTE:
Use FA4482 Tek screws. Do not use the holes
marked with an X in the photo above.
If using the screws supplied with the roller assembly,
drill two (2) pilot holes into the frame and attach roller
assembly using two (2) screws.
Reattach the roller and related parts to the angled
36.
bracket attached to the end wall frame.
NOTE:
Do not tighten the roller assembly at this time. It
is adjusted and tightened when the door is installed.
X
X
Repeat the steps to attach the remaining roller
37.
assembly to the lower-right corner of the rough door
opening. View as seen from outside the frame.
Continue with installing the framing for the back end
38.
wall.
INSTALL THE BACK END WALL FRAME
The end wall framing for the back of the greenhouse is
assembled in the same way as the front end wall.
If the back wall includes the optional double door kit, repeat
the End Wall Installation procedure and install the framing
for the remaining end wall.
CONSULT THE QUICK START SECTION FOR
ADDITIONAL FRAMING INFORMATION.
If the back end wall
does not include
an optional double
door kit, install vertical frame members in the framed
opening. See the diagram below.
Join and cut the tubes to the required length and attach
1.
to the end wall framing.
Attach the frame support at the top and bottom as
2.
previously described.
Continue with installing the end panels.
3.