ClearCube M1032W, Руководство пользователя, Страница: 7 / 15

Page 7 of 15
P/N G0200177 Rev A, 1.0.03.03.2016
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 (512) 652-3500 www.clearcube.com
Rack Rails and Mounting,
Continued
Install outer
rack rails
The picture and table below shows how to install the assembled outer rack rails in a rack.
Step Action
1 Adjust the outer rack rails so that the outer rails
fit snugly in the rack.
2 Align the holes on the front of the outer rail with
the holes on the front of the rack and secure with
the screws provided (see
A
in the adjacent
picture).
3 Align the holes on the rear of the outer rack rail
with the holes on the rack and secure with the
screws provided (see
B in the adjacent picture).
4 Repeat these steps with the other outer rack rail
assembly.
Next step: Install the workstation in a rack.
Installing in
rack To install an M1032W Engineering Workstation in a rack:
1. While carefully lifting the workstation, slide the inner rail extensions into the front of the outer rack rails.
2. Push the workstation into the rack until it clicks into the locked position.
Removing
from rack
This picture and table below show how to remove an M1032W Engineering Workstation from a rack.
1. Press the outer rack rail latch to release the workstation chassis
(the latch is shown in the adjacent picture).
2. Carefully slide the chassis forward off of the outer rack rails and
out of the rack.
A
B