User manual / Bedienungsanleitung
Made in Germany
Page / Seite 5
Take the
swing base
out of the box. Remove the adhesive tape used to secure both parts during
transport.
The upper part of the
swing base
can be put aside for the time
being.
Place the lower part of the
swing base
on the tonearm base,
such that the holes of both bases are aligned.
The arrow on the lower part should point towards the platter
(see picture 4). Use the M4 x 16 screws and the hex wrench
#3 (provided) to tighten the lower part of the tonearm base.
Pic. 4: Mounting of the
swing base
Now you can thread the tonearm cables of the TT5 tonearm through the upper part of the
swing
base
(not yet assembled) and through the opening of the assembled lower part and tonearm hole
of the chassis (see pic 5).
Insert the foot of the TT5 through both components of the
swing base
into the tonearm hole,
allowing the upper ring to rest loosely (see pic. 6).
Pic. 5: Putting the cables through the
swing base
Pic. 6: Inserting the cables in the tonearm base
The installation of the
swing base
is now completed and you are ready to mount and adjust the
TT5 tangential tonearm, following the TT5 user manual.
Once the tonearm has been fully adjusted, you will need to fix the upper part of the
swing base
.
Here, you can opt for the direction in which the tonearm will swung out.
