Bluemotion mit Satisfy
Bedienungsanleitung
Seite 20
clearaudio electronic GmbH 2006
direction.
The following adjustment is very important:
should the air bubble in the level gauge not be in the black
circle (see at the blow up), please ensure then that your
underground so will be according aligned. Only if the
turntable will be aligned you will receive the optimum on
sound.
Take the threaded bolt (metric winding size 6) out of your accessory bag
and screw it with the adequate allen key into the winding near the
tonearm cut of the turntable chassis, so that the front of the bolt is not
facing out the inner side of the tonearm cut.
Now it’s the right time to mount your cartridge on your
Satisfy
-tonearm.
Please use the manufacturer´s instruction manual while this installation
procedure and follow the appropriate instructions. The headshell wires
( cartridge connection leads ) are colour coded according to the international standard :
Please pay attention on every step to avoid any damages to the cartridge !
Now take the three Flat-Pads and place them directly below
the hole for the tonearm in the turntable-body as shown in
the beneath picture.
Then take the
Satisfy
-Tonearm with the mounted cartridge
(and the stylus protector) and slide first the grounding wire
and then the tonearm´s shaft (the part with the rca-jacks)
into the pre-drilled hole on the right side of the
Bluemotion
-Turntable body. Push the tonearm as far into the hole until
the shaft of the tonearm sits on the three Flat-Pads.
Please ensure that the tonearm tube is in parallel to the
right edge of the turntable body. Fix this position while
gently locking the allen screw in the turntable-body´s edge.
Now adjust the tracking force of the cartridge. Please follow
the instructions according the manual of the cartridge you
use. If you are using a
clearaudio
Moving Magnet cartridge (e.g.
clearaudio
aurum
classics Wood
) you can adjust the force (about 20 mN), by turning the tonearm´s counter
weight on the threaded bolt until you can see approximately eight threads (backside view of
the tonearm). This works only if the lead plate, which is part of delivery of the clearaudio
cartridge, is not mounted under the cartridge.
Colour code of the Satisfy tonearm wire:
Signal left channel (L+)
→
white
Signal ground left channel (L -)
→
blue
Signal right channel (R+)
→
red
Signal ground right channel (R -)
→
green
