Ambient
User manual
Seite 15
clearaudio electronic GmbH 2008
VTA adjustments are accomplished by loosening the two lock screws an the side of the
armboard base (shown in picture 1 and 2). Once loose, you can moove the arm up or
down to achieve the desired VTA. Tighten both screws when finished. Re-check tracking
force after adjusting VTA.
Azimuth adjustments are facilitated through the small (1,5 mm) Allen screw (red marked
screw) on the bottom side of the armwand where the headshell enters the carbon fiber.
Once you loosen this screw, you´ll be able to rotate the headshell a small amount in
either direction. Be sure to tighten the screw when done.
1 2
Pic. 14:
VTA-adjustment
Pic. 15:
Azimuth adjustment
