Page 3 of 21
Power Status
The Power LED shall be on when the device is plugged in and has power.
Ethernet Status
The Ethernet LED should be on when the LAN Ethernet has been established and activity has
been detected.
Signal Strength
Once the device has registered on the network, the Signal Strength LEDs should be on
depending on different strength. Only one Signal Strength LED lit represents low signal
detected and all five Signal Strength LED lit presents high signal detected.
Back Panel Ports Description
Power AC Power Connector
Phone Line RJ-11 port for use with VoIP.
Ethernet Port
Reset button
Note: Hardware Reset Button (A paper clip is recommended for accessing this button). Before
resetting the CPE, ensure the power LED is ON. Hardware Reset Button will cause
PASSWORD, DEVICE NAME and LAN IP to be restored to default. If you would like to reset to
default as ex-factory setting, please do it via Basic/Restore Factory Settings.
Operating Information
Operating temperature for this
unit is 0℃-40℃ (32-104F).
Installation
Overview
To install the Desktop CPE Series, you need to review the following sections:
Before You Begin
Easy Setup
Before You Begin
Before you begin installation, check that you have received the following items with your
Desktop CPE:
In the box with your CPE you should have:
Item Description
Power Adapter
Power adapter connects the Clear Modem to an AC electrical outlet.
