Clear-Com ICS-21, Инструкция по эксплуатации

Страница: 8 / 32

I C S - 2 1 / 2 1 D T S P E A K E R S T A T I O N
1 - 4
Tone Alerts
Tone alerts are set through the configuration program. The station has the
following three tones:
Table 1: Tone Alerts
REMOTELY CONTROLLED OPERATION
The ICS-21 can be programmed to be remotely controlled. This feature can be a
benefit when the ICS-21 is used in a location where it is not possible for the
person speaking on it to control it. This feature can also be used to remotely
monitor locations.
Remotely controlled operation must be enabled both in the ICS-21 and in the
Matrix System. To set remotely controlled operation in the ICS-21, use the
following steps:
1. Remove power from the ICS-21.
2. Remove or partially remove the ICS-21 from its outlet box or enclosure.
3. Set Option Switches S1-2 and S1-3 to the ON position, towards the front
panel. Refer to Figure 2.
4. Fasten the ICS-21 into its box or enclosure and reconnect power.
To set remotely controlled operation for the ICS-21 in the Matrix System, use
the following steps in PGM-WIN program:
1. From the FILE menu, select ON-LINE TO MATRIX .
2. From the SETUP menu, select HARDWARE and LABELS . Assign labels to
the stations by clicking on the TALK LABEL for the port the station is
connected to and typing in the label you want the station to have. For this
example, the ICS-21 station will be named ICS21 and the master station will be
named 2003.
3. Select the ATTACHMENTS tab.
4. Click on the ROUTES button.
TONE MEANING
Four rapid beeps Call signal
Two beeps Label change
Single beep Monitoring
• You can remotely control
the ICS-21 speaker
station.
• Remotely controlled
operation must be set up
both in the ICS-21 and in
the Matrix System.