23
EN
Operation
PLEASE NOTE!
■
Make sure that there are no large, pointy objects on the area to be cleaned.
■
Pay attention to the dust container’s
MAX
mark. If the mark is reached during use, em-
pty the dust container. Empty and clean the dust container after each use. The HEPA
fi
lter must also be cleaned regularly to prevent the motor from being overloaded.
■
Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the “Charging Up the Battery” chapter).
When the device is switched on, the charge status of the battery (
4
) is indicated
by the two green battery charge status lamps (
1
). If both lamps are lit up, the
battery is full. If only the red operating lamp (
1
) is lit up, the battery needs to be
charged up.
1. Select an accessory as required (see the “Device Overview” chapter – “Accesso-
ries”) and attach it to the device (see the “Assembly” chapter).
2. Switch the device on. This can be done in one of two ways:
– by gently holding the On / Off switch (
2
) down. The device will switch off when you
let it go.
– by
fi
rmly pushing the On / Off switch once and then releasing it. If you would like to
switch the device back off, push the On / Off switch again.
3. The device will immediately start to vacuum clean. The operating lamp and the
battery charges status lamps are lit up.
4. Run the device over the area to be cleaned.
5. After vacuuming, switch off the device.
6. To ensure that the device operates optimally, empty and, if necessary, clean the dust
container (
7
) after each use (see the next chapter).
Cleaning and storage
PLEASE NOTE!
■
Do not immerse the HEPA
fi
lter and the foam
fi
lter in water or rinse it under running
water to prevent damage. They are
neither machine-washable, dishwasher-safe
nor suitable for tumble drying.
■
The
fi
lter holder is not suitable for the washing machine, dishwasher or dryer! Only
air dry the
fi
lter holder and do not in any case use a hair dryer.
■
Do not use any corrosive or abrasive cleaners to clean the housing. They could
damage the surface.
The HEPA
fi
lter may lose some of its colour over time. This is normal and
does not have any adverse effect on function.