Safety, Operation and Maintenance Manual for Eagle (RA 700 B / RA 701 B);
8
OPERATING THE AUTO-SCRUBBER
Turn on the different applications in the following order by pressing switches:
1. Turn on main switch (D8)
2. Turn on key switch (B8)
3. Push button for solution (B3), if necessary adjust water flow (A7)
4. Push button for vacuum motor (B1)
5. Push button for brush operation (B2)
6. Pull the drive switch lever (B4)
Drive the first 10 to 15 feet to test the water flow
as well as the chosen brushes or pads and
make sure that these meet the requirements to
properly clean the floor.
At the same time check the vacuuming
performance. If necessary adjust the squeegee
angle by using the squeegee angle adjustment
screw (D4).
To adjust the drive speed turn the speed knob
(B9). For faster operation turn clockwise, for
slower operation turn counter-clockwise.
IMPORTANT INFORMATION
•
When the machine is not being operated or
stopped, immediately turn of the brush in
order to avoid damage to floor surface.
•
If either liquid or foam leaks from machine
unintentionally, immediately switch off the
machine. Add defoamer to prevent foam
entering the tube of the vacuum motor.
•
Check filling level regularly and empty
recovered water in time. Make sure enough
water is dispensed whilst running the
brushes or pads as these should never be
run dry.
•
Use brushes, pads and accessories as
described in this operations manual. Failure
to comply with this can be hazardous.
•
When leaving the machine unattended,
disconnect cable/battery plug and safeguard
machine from unauthorized use.
•
The working place of the operator is behind
the handle of the machine.
•
The maximum incline for the machine to be
operated on is 10%.
ATTACHING AND REMOVING BRUSH OR PAD DRIVER
•
Lift the brush housing (A4) with the brush
pedal (D1). Make sure that the pedal is safely
locked into position.
•
Remove the brush or the pad holder with a
quick turn.
•
The brushes or pad driver are attached by
holding them under the brush housing and
then turning them clockwise or counter-
clockwise into the holding brackets.
•
Make sure that brushes or pad holder are
properly attached before turning on the brush
switch (B2). The brushes and/or pad holder
will lock in place by briefly turning on the
brush motor (B2).
