Cleaner Wash CW1400-3F, Руководство пользователя

Страница: 13 / 21

• Hold the spray gun with both hands. Direct the
water jet to the object to be cleaned and press
the trigger.
Release the lever of the trigger gun; the device
will switch off again and stop the water jet. High
pressure remains in the system.
WARNING! Beware of kickback when pressing
the trigger!
Operation with detergent
Detergent can only be added when the device
is operated in low pressure mode.
DANGER
When using detergents, the material data safety
sheet issued by the detergent manufacturer
must be adhered, especially the instructions
regarding personal protective equipment.
Remove the cap of the clean detergent bottle.
Gently pull the onboard detergent tank out of its
storage position.
Fill the tank with detergent designed specifically
for use with pressure washers.
Push the detergent bottle with the opening
pointing downwards into the connection for the
hose clean detergent.
Recommended cleaning method
• Spray the detergent sparingly on the dry
surface and allow it to react, but not to dry.
• Spray off loosened dirt with the high pressure
Met.
After operation with detergent
• Remove the hose clean detergent bottle from
the intake and close it with the lid.
• For storage, put the detergent bottle into the
retainer with the cap pointing up.
Vacuum Cleaner operation
CAUTION
Make sure the on/off switch is set to “OFF(O)”
and insert the plug into a properly installed
socket.
Adjust air flow
Open the air flow block , suck power will come
down. If close the block , suck power will max.
power.
•
Turn on the switch “VAC(II)", then can use it to
clean.
Interrupting operation
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Put the trigger gun with the spray lance into
the parking position.