Tannin 5900e Installation & Startup Guide
Page 14
www.cleanwaterstore.com
Rev 062915
Master Programming Mode
Entering Master Programming Mode
-To enter Master Programming Mode press and hold both buttons for 5 seconds.
1. Regeneration Type (t)
This display is used to set the Regeneration Type. This option setting is identified by the letter
‘t’ in the left digit.
Your Tannin filter should be set only to : [ t - - c ] for Time Clock.
Timeclock Filter Delayed
- The control will determine that regeneration is required when the
set Regeneration Time has been reached. The Regeneration Frequency setting will determine
which days a regeneration cycle will be initiated.
Example: [ t - - c ]
2. Regeneration Time (r)
Press the Menu/Enter Button. The next display viewed is the option setting for
Regeneration Time. It is identified by the letter ‘r’ in the left digit. Set the desired time of day
that a regeneration may occur, if required.
We recommend setting the system to backwash
at 2 AM
, or at any time that it is unlikely that any water will be used. The first digit(s)
indicates the Hour and the other digit indicates A.M. or P.M..
Example: 2 A.M. regeneration time - [ r 2A ] (factory setting)
3. Regeneration Cycle Step Programming (1)(2)(3)(4)
The next 4 displays viewed are part of a series of option settings used to program the
Regeneration Cycle. Up to 4 steps can be programmed, however, some steps may not be
necessary for your application and will be set to 0. Each display is used to set the duration
time in minutes for that specific step in a regeneration cycle. A step # will turn on for the
regeneration cycle step being programmed. Regeneration steps are
skipped
by setting the
display to 0 as shown below:
Examples: Regeneration Cycle Step #1 - 10 minutes - [ 1 - 10 ] (Factory Setting)
Regeneration Cycle Step #2 - skipped - [ 2 - - 0 ]
Set each step according to the values below, appropriate for a Tannin filter:
1
8 minutes. This is the Backwash cycle.
[ 1 - 8 ]
2
60 minutes. This is the Brine Draw cycle.
[ 2 - 60 ]
3
6 minutes. This is the Rapid Rinse cycle.
[ 3 - 6 ]
4
For the Brine Refill Cycle, set the time according to the size of your system below:
1.0 C.F. - Set to 12 min;
1.5 C.F. - Set to 18 min;
2.0 C.F. - Set to 24 min;
2.5 C.F. - Set to 30 min.
Example: [ 4 - 12 ]
