Tannin 5900e Installation & Startup Guide
Page 13
www.cleanwaterstore.com
Rev 062915
Programming Your Valve
*While scrolling through numbers, it only increases the value. To decrease the value, you will
have to “go all the way around” to get back to a lower value.
1. To enter main menu press the Menu/Enter button
(Time of day will flash)
2. To set time of day press the Set/Change button
(First digit will begin to flash)
Example [ 12:00 ]
- To change digit value press the Set/Change button
- To accept the digit press the Menu/Enter button
- (Next digit will flash)
- (Once hours is accepted all digits will flash)
3. With all digits flashing press the Menu Button to set A.M. or P.M.
- (Once A.M./P.M. is accepted the next menu item will flash)
Example [ A ]
4. To Set Regeneration Frequency Press the Set/Change Button
- The recommended setting for a Tannin filter is every 2 days
- Once the last digit is accepted all digits will flash
Example [ A - 07 ]
Notes: -Maximum Value is 29
-If value is set to 0, automatic regeneration will never occur
-One cycle must be completed before new setting will be accepted.
5. To exit menu press the Menu/Enter button
Note: If no buttons are pressed for 60 seconds or longer the menu will
automatically be exited.
Next you will need to set the Master Programming to be used as a Tannin filter, continue on to the
next page to finish the programming instructions.
