Air Charger Sulfur Filter 5900e-AIR Installation & Startup Guide
Page 13
www.cleanwaterstore.com
Rev 082616
5900 Air Charger Sulfur Filter 5900e-AIR up to 4 feet above the top of the tank. If the drain line
will be more than 20 feet, use larger diameter tubing such as ¾” or 1”. Note that it is desirable
to be able to run the drain line into a bucket in order to test the backwash flow rate in the
future. This is why hard piping the drain line is discouraged: however, if you do use hard PVC
piping for the drain line, and you are able to remove the hard PVC drain piping and attach
flexible tubing should you ever desire for testing purposes, it is OK to use rigid PVC pipe for the
drain. Make sure the drain tubing is firmly clamped to the barbed fitting with a hose clamp to
prevent leaks.
12.
Next, you will need to program the system to work as an Air Charger Sulfur Filter 5900e-AIR
Filter. There are a few settings that must be changed before the system can be put into service.
Plug in the control valve and continue on to begin the programming instructions.
Programming Your Valve:
*While scrolling through numbers, it only increases the value. To decrease the value,
you will have to “go all the way around” to get back to a lower value.
1. To enter main menu press the Menu/Enter button
(Time of day will flash)
2. To set time of day press the Set/Change button
(First digit will begin to flash)
- To change digit value press the Set/Change button
- To accept the digit press the Menu/Enter button
- (Next digit will flash)
- (Once hours is accepted all digits will flash)
3. With all digits flashing press the Menu Button to set A.M. or P.M.
- (Once A.M./P.M. is accepted the next menu item will flash)
Example [ A ]
4. To Set Regeneration Frequency Press the Set/Change Button
The recommended setting for an Air Charger Sulfur Filter 5900e-AIR filter is every 2-4
days depending on how bad the odor is and if there is iron or sediment present.
- Once the last digit is accepted all digits will flash
Example [ A - 03 ]
-If value is set to 0, automatic regeneration will never occur
