CLEAN COMFORT DV090, Инструкция по установке и эксплуатации

Страница: 6 / 20

DUCTING
Figure 2B
Note: If not using
ventilation damper,
do not remove
knock out.
IO-DV090 IO-DV090
WWW.CLEANCOMFORT.COM 6
Figure 3
Step 2
. Attach the 10” diameter return duct collar using
six #8 screws provided.
Adjust damper to desired position. Open (Fig 2G) or closed (Fig 2E)
Figure 2E
Figure 2G
Figure 2F
Fasten duct collar to cabinet using four #8 screws provided. (Fig 2F)
Note desired orientation of damper control lever. (Fig 2E)
Remove knock out using side cutters. Discard
Figure 2D
Figure 2A: Attaching duct collars to the DV090
Step 1.
Attach 6” diameter fresh air ventilation
damper. (if desired)
Safety Float Switch the DV090 and the dehumidifier will
shut off. If the blue wire is in series with the Safety Float
Switch the compressor will turn off but the DV090 will
continue to ventilate or circulate air as normal. Contact
your local electrician to install the safety float switch
directly to the dehumidifier.
For installation guidelines, refer to the "Condensate Pump
Installation" section at the back of this manual.
Ducting
Installing Duct Collars
The DV090 comes supplied with 10” and 6” round inlet
collars and a 10” round exhaust collar. Follow instructions
included with these collars.
Figure 2C