Lithium Power Supply User Manual
Page
12
6. General Instructions
ATTENTION: Before installing, make sure that all appliances are turned off.
When installing the LPS the following connections can be used.
-
230VAC Input for charging from external mains plug (Blue Neutrik. Assembly described in section 6.3)
-
230VAC output to power 230vac equipment (Grey Neutrik. Assembly described in section 6.3)
-
12VDC Input for charging from the car generator (12VDC input, Grey Anderson SB50. Assembly
described in section 6.6)
-
12VDC output to power 12VDC equipment (12VDC output, Red Anderson SB50. Assembly described in
section 6.6)
6.1. Installation / Use of 230VAC Input
When connecting the LPS1512-100Ah to a 230VAC source, the unit will start up and begin to charge the
internal battery. Please note that when a 230VAC source is connected the unit will loop the 230VAC directly
through to the output sockets, enabling 230VAC out.
Note: Always use a RCD protected source to supply the LPS 1512-100Ah from 230VAC.
When installing the LPS into a vehicle it is important that the 230VAC in is supplied from an unbroken cable
from the external power source to the 230VAC input on the LPS as shown in figure 4.
If the 230VAC charge wire is connected to anything else, an RCD must be present immediately after the
input socket as shown in figure 5.
Figure 4
Figure 5
LPS
230VAC'
LPS
230VAC'
RCD