Clatronic DBS 3187 R, Инструкция по эксплуатации

Страница: 32 / 54

E
N
G
LI
S
H
ENGLISH
32
Iron or Steam Brush
Please decide before you start which accessory you need.
• Release the plug (13) if necessary by pressing the buttons
and pulling the plug.
• Change to the required accessory by inserting the plug (13)
of the accessory.
NOTE:
• On the plug there is an arrow which must be facing
upwards.
• Please check whether the plug is fi rmly in place by pulling
on it again. The plug must not become loose.
Steam Jet Button
on the iron: Press the steam jet button (3) to release
a jet of steam. Press the button again to
stop the jet of steam.
on the steam brush: Hold the button down for as long as you
need the steam. Release the button to
stop the jet of steam.
WARNING:
• Do not change the accessory while the device is still hot
and therefore under pressure. Steam may be ejected
unexpectedly.
• Turn the device off in order to allow it to cool down for 15
minutes.
Water Tank
• Press the button (8) if you would like to remove the water
tank (see also illustration A).
• This makes it easier to fi ll in water. The contents of the tank
are 1200ml.
Water
Please use only distilled water. Do not use any decalcifi ers!
These will destroy the device!
The following is also unsuitable: Do not fi ll battery water,
water from the clothes dryer and water containing additives
(such as starch, perfume, softener or other chemicals) into the
water reservoir.
This could damage the iron due to residues forming in the steam
chamber. These residues may cause impurities to the fabric
when dropping out of the holes in the soleplate.
Before Initial Use
Clean the ironing base with a slightly damp cloth.
CAUTION: INITIAL USE
Please proceed as follows:
• Connect the iron.
• Fill the tank up to the maximum mark. Do not overfi ll!
• Close the water tank and place it back in the base.
• Connect the base station to a 230 V / 50 Hz socket with
earthing contact.
• Turn the switches (11) and (12) on.
• Turn the temperature control to
MAX.
The control lamp on
the iron lights up.
• Please wait until the control lamp (9) on the base lights
up.
• Now press the steam jet button for at least 1 minute.
NOTE:
• This time is needed for the steam to reach the iron.
• Keep a cloth ready! During this phase water also
comes out of the soleplate of the iron.
• When only steam comes out without any water you can
stop the procedure. Then press the steam jet button
another 2-3 times without touching the clothes that are to
be ironed.
• After you have ironed an old but clean cloth a few times,
your station is ready for use.
Operation
Ironing without steam
NOTE:
• Sort out the garments according to their ironing tempera-
tures.
• Always set the temperature control to „ MIN “ before
connecting the appliance to a power point, or before
disconnecting it.
• Place the iron on the rest.
• Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
• Turn the switch (12) on.
• Set the temperature on the temperature control (4). If you
have sensitive items to iron, please begin with the lowest
temperature.
• The control lamp on the iron shows that it is heating up. As
soon as the control lamp goes off the operating temperature
has been reached. Now you can start ironing.
• After use always turn the temperature control to „
MIN
“ (the
control lamp in the handle goes off) and turn the switch (12)
off.
05-DBS 3187 R.indd 32 05-DBS 3187 R.indd 32 21.09.2007 10:48:33 Uhr 21.09.2007 10:48:33 Uhr