Clatronic BS 1280, Инструкция по эксплуатации

Страница: 27 / 46

27
Parquet brush: The parquet brush is itted with
rollers for improved manoeu-
vrability.
For large areas such as parquet,
laminate or tiles etc.
Releasing the nozzles: Pull these off while turning
slightly.
Maintenance
Filter
Your machine has four ilter systems. The traditional dust
bag system has been replaced by a transparent dust
container. In this, coarse dirt particles and tiny particles
loating in the air are swirled out of the suction air by the
high speed of the air current.
It is therefore unnecessary to buy dust bags.
Emptying the dust container
Empty the dust container when the amount of dust
reaches the “MAX” mark. Proceed as follows:
• Remove the mains plug from the
socket.
• Press the button (8) to release
the dust container and remove
the dust container (Fig. G).
• Hold the dust bag over a rub-
bish bin. Empty the contents of
the dust bag. To do so, press
the release button for the dust
container lid (14) (Fig. H).
• Close the base plate again so
that it is heard to lock into place.
Motor protection ilter (in the dust container)
Cleaning the ilter (Cyclone unit)
• Remove the mains plug from the socket.
• Press the button (8) to release the dust container and
remove the dust container (Fig. G).
• Hold the dust bag over a rubbish bin. Empty the
contents of the dust bag. To do so, press the release
button for the dust container lid (14) (Fig. H).
• Close the base plate again so that it is heard to lock
into place.
• Unlock the dust container lid by turning it a short way
anticlockwise. Remove the lid.
• Remove the motor protection ilter and clean by tap-
ping it.
• Unlock the cyclone unit by turning it a short way
anticlockwise. Remove the cyclon unit and clean it.
• Insert the cyclone unit back into the dust container
and lock it by turning it clockwise.
• Insert the motor protection ilter.
• Replace the lid and lock it by turning it clockwise.
• Replace the dust container until you hear it click into
place.
Every third time the dust
container is emptied,
or in the case of severe
soiling, clean the ilter
by allowing water to low
through the ilter fabric
against the direction
in which the vacuum
cleaner blows.
The dust container should only be reinserted when it is
completely dry!
CAUTION:
Never wash the ilter in the washing machine, and
please do not use a hairdryer to dry it.
HEPA ilter
Your appliance also has a HEPA ilter. You will ind this
ilter under the ilter cover on the back of the appliance. In
order to ensure that the ilter works correctly, we recom-
mend that you replace it every six months.
• Remove the mains plug from the socket.
• Open the ventilation grille by pressing the “PUSH”
button at the bottom on the ventilation grille.
• Remove the grille. Remove the ilter and clean as
described. Put the ilter back in. Close the ventilation
grille until you hear it click into place.
CAUTION: Important note!
Cleaning may become necessary after a shorter time,
depending on the conditions of use, e.g. when vacuum-
ing ine dust.
If the suction power of your vacuum cleaner diminishes
please clean the ilters as described.
If the suction power suddenly diminishes during opera-
tion this may be due to the ilters being locked.