17
o The cable connections must be in accordance with the diagram located
on the bottom of the hob (see above).
o You should use a good quality screwdriver to carefully, fully tighten
ALL of the terminal screws.
o
When the hob is first switched on, if only two of the zones work, you
should recheck that the terminal screws are all fully tightened. This
should be done before contacting an Authorised Service Agent.
o
IMPORTANT: The appliance must NOT be connected to the mains
supply by means of a 13A plug and socket.
o The cable can be looped if necessary, but make sure that is not kinked or
trapped when the hob is in position. Care must be taken to avoid the
cable being in contact with hot parts of the appliance.