© 2017
w w w . c l a s s i c e x h i b i t s . c o m
Step 1 of 5
Order #XXXXX
Backwall Assembly
4
1
5
8
8A
1
4A
5A
3
3A
6A
7A
2
2A
6
7
Power
Break
Completed Backwall Assembly
Power
Break
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
SEG Graphic Installation
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
Item
1
2/2A
3/3A
4/4A
5/5A
6/6A
7/7A
8/8A
Qty.
2
1/1
1/1
1/1
1/1
1/1
1/1
1/1
Description
Base Plate
42”w S40 Vertical Extrusion
42”h S40 Vertical Extrusion
42”h CEI110 Horizontal Extrusion
42”h CEI110 Horizontal Extrusion
42“h CEI110 Vertical Extrusion
42“h CEI110 Vertical Extrusion
40.1767“h Z45 Vertical Extrusion
Steps:
1) Attach Base Plates [1] to Vertical [2] & [3], using bolts.
3) Assemble CEI-110 Extrusions together, with Verticals [8,8A] between.
See General Information page CEI-110 Frames Assembly for details.
4) Connect Verticals [2,2A] and [3,3A] together then attach to each side
of assembled CEI-110 frame. See
CEI-110 to S40 Connection
detail.
5) Connect lighting power cords and attach transformers.
See
Light to Light Connections
&
Light to Transformer
details.
6) Apply SEG graphic and blocker to front & back of assembled frame.
See
SEG Graphic Installation
detail.
V4 Connector
CEI-110
S40
Slide V4 Connector into groove of S40. Tighten
set screw to secure V4 Connectorin place at
correct elevation. Insert Screw Cap stud through
hole of CEI-110 into threaded hole of V4 connector.
Tighten Screw Cap to secure in place.
CEI-110 to S40 Connection
Screw Cap
+
+
+
-
-
-
to power
Lights
Male
Male
Female
Female
Transformer
Light to Light Attachment
Light to Tranformer Attachment
