-8-
FRONT PANEL AND CONTROLS:
8
Threshold
This allows you to ignore weak, noisy stations by adjusting the station capture threshold. This is
particularly useful when using
Autostore
.
While in any mode press and release the
SIGNAL
button on the faceplate or remote, then press and
hold. The display will illuminate with small bars for around 2 seconds then the display will change
to
‘th 1’
or whatever level the threshold may have been previously set at. This indicates that any
stations found above signal strength 01 will be played. When
‘th xx’
is shown on the display, the
threshold can be adjusted upward by turning the tuning knob to the right or downward by turning it
to the left. The maximum threshold is 31. Pressing either
TUNE
or
PRESET
will take you back to
the main tuner functions.
9
AutoStore Function
This tuner has the facility to scan through the band and store the stations that it finds automatically.
While in
tune mode
, press the
STORE
button. The TUNER-1 will show the next lowest available
preset location in which the frequency can be stored. This will determine where the tuner will start
storing the presets when the autostore function is executed.
Press and hold
STORE
. The display will illuminate with small bars for around 2 seconds then the
display will change to
‘ -’
(flashing). This indicates that the tuner is searching for stations. After a
few seconds the display will revert back to preset mode with all the new stations available above the
selected threshold store in the programmed.
10
Stereo and Mono
Stereo and Mono control is only available with the remote wand.
11 Display Functions
This function will allow you to dim or turn off the display. There are 3 brightness settings for the
display. Pressing and holding the
DISPLAY
button will allow you to choose from one of these 3
settings, the display will show sequentially ‘bri.1
, bri.2, bri.3’,
from the dimmest to the brightest
setting. Release the display button when you have reached the desired setting.
Pushing and releasing right away the
DISPLAY
button will turn off the display. To bring back the
display, press any function.
NOTE: The
DISPLAY
function is accessible only through the front
panel.