-4-
UNPACKING & SET-UP
The Classé
TUNER ONE
has been carefully wrapped in heavy gauge plastic, packed in semi-
rigid foam and packed in a special box. To remove the unit, open and spread the top flaps of the box.
By its sides, lift out the entire unit with the foam pieces attached. Remove each foam side by pulling
straight out. Remove the plastic wrap and inspect the unit for any concealed damage.
Apart from this owner's manual, please ensure the following is also included:
1) Detachable A.C. power cord.
2) Remote control handset (along with allen key and two (2) type "AAA" batteries).
Report any damage or missing parts to your dealer immediately
.
The TUNER must be located in a position free of any hum-inducing magnetic fields.
Permanent placement adjacent to power amplifiers, A.C. line filters, or regulation devices should be
avoided. Ideally, a few feet should separate the TUNER from the power amplifier. As well, keep low-
level interconnect cables away from the power amp and separate from A.C. line cords. Experimentation
with placement will show you how close to your other equipment you can place the Classé Tuner in
your own system
Heat generated by the Tuner is negligible. Air space around the unit need not be a concern, but
like all other electronics, it should not be enclosed in a cabinet which will become overheated by other
components.
Check the Serial Number sticker on the back of the unit for the correct operating voltage.
Regardless of voltage, the fuse rating should be
.
8 AMP SLO-BLO.