CLAS PE 6002, Руководство пользователя

Страница: 38 / 60

PE 6001
DOUBLE SCISSOR LIFT 3T
PE 6002
SCISSOR LIFT 3T DUAL CYLINDERS LOW RAISE
RISK OF FALLING OFF - PERSONNEL
During up and down operations personnel are prohibited from entering the platforms and
the vehicle lifted to avoid falling off.
RISK OF FALLING - VEHICLE (Figura 11)
This danger may arise if the vehicle is incorrectly positioned on the platform or in the case
of vehicles of a size that does not conform to the lifting capacity. When the lift is in use, the
engine of the lifted vehicle must not be switched on. You should not place any object on the
platform and on the mobile parts of the lift but vehicles.
RISK OF SLIDE
Any lubricant contamination in the underlying area and immediately around the lift and
the platforms must be cleaned immediately. Immediately remove any oil spills. Keep the
working area clean.
RISK OF ELECTRIC SHOCK
The risk of electric shocks in isolated areas of electrical equipment has been canceled. Do
not use water jets, steam or paint solvents next to the lift and the control unit, and pay
special attention to keeping these substances away from the electrical control panel.
RISKS RELATED TO INAPPROPRIATE LIGHTING
The operator, installer and maintenance personnel must be able to ensure that the area
where the lift is operating is illuminated properly and uniformly in accordance with the laws
in force at the site of installation.
RISK OF VEHICLE FALL FOR WRONG POSITIONING (figure 12)
The center of gravity of the vehicle must be located in the lift area shown in figure 12
During up and down operations, the operator must keep the lift under constant control and
must maneuver only from the indicated position.
Handling of safety devices is strictly forbidden. Never exceed the maximum lifting weight
and make sure that the vehicle that is being lifted does not have any load on board.
It is essential to strictly comply with all operating, maintenance and safety standards
contained in this manual.
Picture 12
38