CLAS OC 0039, Руководство пользователя, Страница: 6 / 12

OC 0039
TOOL TO HOLD THE CYLINDER HOOD/HATCHBACK
INTRODUCTION
It is compulsory to read this instruction manual before starting any kind of action.
The proper operation and full compliance of this product’s performance is guaranteed only if all
the instructions provided in this manual are closely adhered to.
We guarantee that this product complies with the technical specifications described in this manual.
The manufacturer shall not be held responsible for any improper uses other than those described
herein.
Misuse:
• This product should only be used as described in this documentation; any other use is considered
improper.
• The manufacturer accepts no responsibility for any damage caused by the incorrect or
unreasonable use of the equipment.
• Moreover, misuse shall also void the warranty.
Take care of your tools:
• Be sure to store your tools in a clean state.
• Place the tools inside their original package.
Carefully read all instructions, warnings and precautions.
During system operation, observe all safety regulations to avoid injury or equipment damage. In
case of doubt regarding safety or applications, contact Clas. Failure to observe these precautions
could result in serious equipment damage and personal injury.
PRECAUTION : indicates correct operating or maintenance procedures to avoid damage to the
equipment or to the surrounding environment:
• Check the correct operation of the tool and its integrity before use,
• Clean any dirt on the strut shaft, opposite to the one to be replaced, and on which to fix the
clamp,
• If it is used to replace bonnet struts, wait until the engine is completely cold.
WARNING : indicates a potential hazard that requires putting into practice the correct procedures
to avoid accidents:
• When replacing bonnet struts, always wear personal protective equipment (gloves, safety
goggles with side shields, safety shoes and work clothing).
SAFETY PRECAUTIONS